| Forum Home | ||||
| Press F1 | ||||
| Thread ID: 63716 | 2005-11-20 20:49:00 | Maxtor Hard Drive Jumpers | GrahamB (750) | Press F1 |
| Post ID | Timestamp | Content | User | ||
| 405877 | 2005-11-20 20:49:00 | I have a Maxtor HD that has previously been used as a Master and I want to use it as a Secondary HD. The pins on the back are in 2 rows, a total of 9 pins. Viewing them I count 123(4missing)5 on top left to right, and on the bottom 6 to 10 left to right. The jumpers fitted as Master connected 1 & 6 (left hand end) and 2 & 3. Having removed both jumpers, it is not being recognised. Maxtors site suggested slaves should have no jumpers at all, but then there was no reference to a jumper between 2 & 3 on any Master. Any suggestions would be appreciated. Regards GrahamB |
GrahamB (750) | ||
| 405878 | 2005-11-20 20:59:00 | Because Maxtor have different jumper configurations, I went to Maxtors site, and went searching for jumper settings Click here (www.maxtor.com) Choose the model harddrive you have (will be on a label on the harddrive) Then select installation>jumper settings All going well you will get a popup with the settings you require :) Edit, or it can be listed under technical information on some listings |
Myth (110) | ||
| 1 | |||||