| Forum Home | ||||
| Press F1 | ||||
| Thread ID: 67290 | 2006-03-23 13:48:00 | Philips 190s doesent like my RADEON 9550 hlp plz | fawa (10053) | Press F1 |
| Post ID | Timestamp | Content | User | ||
| 440200 | 2006-03-23 13:48:00 | Basically the systems Im running work fine running 2D apps but start any 3D app and the ATI vpu recovery kicks in with 'vpu not responding' or the monitor will reset and give 'refresh rate not supported' RADEON is 128meg not sure of vendor. I've tried the following; Used CAT-uninstaller to remove the 'old ATI drivers' I have downloaded and installed the latest RADEON driver from ATI. Installed DirectX 9.0c It's so bad that Catalyst Control Centre will trigger the 'vpu not responding' message if I click on the '3D Standard settings tab' Any ideas would be much appreciated |
fawa (10053) | ||
| 440201 | 2006-03-25 16:05:00 | bump | Laura (43) | ||
| 440202 | 2006-03-25 23:02:00 | What are the specs of your computer (other than the monitor and grafix card)? Is the card a new addition. Try downloading drivercleaner, run it in safe mode, then install the new drivers |
Myth (110) | ||
| 1 | |||||