| Forum Home | ||||
| Press F1 | ||||
| Thread ID: 73908 | 2006-11-05 09:24:00 | CMOS check sun - Default Loaded | chinadoll (682) | Press F1 |
| Post ID | Timestamp | Content | User | ||
| 496584 | 2006-11-05 09:24:00 | Hi, I just bought a Foxconn 865PEAD-S motherboard to replace my dead Asus P4C800 motherboard but I am having a hard time to configurate it. The motherboard has 2 IDE connectors and 2 Sata connectors. The system set-up was: 1 DVD Rom connected on IDE Primary connector (dvd rom on master jumper) 1DVD Writer connect on IDE Nothing on IDE Secondary connector Primary Slave (DVD Writer on slave jumper) 1 sata HDD connected on sata0 Nothing on sata1 When I start up the computer it gives me this message CMOS CHSK SUN-DEFAULT LOADED.So I have to go to CMOS SETUP UTILITY-ON CHIP IDEDEVICE-ON CHIP SERIAL ATA change from [disable] mode] to [enhanced] mode. Then save & exit. But it will not save the setting I had changed if I shut down the computer then turn off power switch at the back of computer box. (If I don’t switch off the power the setting [enhanced mode] will still be there for next time to use. Can any help me please? Chinadoll. |
chinadoll (682) | ||
| 496585 | 2006-11-05 09:32:00 | It will be a flat CMOS battery. It looks about the size of the old 10cent piece on the motherboard. They can be easily replaced and available at Supermarkets and Dick Smith. |
pheonix (36) | ||
| 496586 | 2006-11-05 09:34:00 | If you still have your old motherboard, how about swapping the batteries with that. | pheonix (36) | ||
| 496587 | 2006-11-05 10:05:00 | thanks pheonix, I will go to get a cmos battery tommorrow. |
chinadoll (682) | ||
| 496588 | 2006-11-06 10:44:00 | Hi, Just to let you know it work fine after changed the battery. Thnak you for you help. Chinadoll |
chinadoll (682) | ||
| 496589 | 2006-11-06 19:36:00 | Hi, I just bought a Foxconn 865PEAD-S motherboard to replace my dead Asus P4C800 motherboard 1 DVD Rom connected on IDE Primary connector (dvd rom on master jumper) 1DVD Writer connect on IDE Nothing on IDE Secondary connector Primary Slave (DVD Writer on slave jumper) 1 sata HDD connected on sata0 Nothing on sata1 Bad move. Why not ditch the DVDRom - the DVDWriter does the job of both... |
pctek (84) | ||
| 496590 | 2006-11-07 09:47:00 | Hi pctek, I had throught about that to ditch the DVDRom. It will leave a hole on my box so I just leave there. Thanks for advice. |
chinadoll (682) | ||
| 1 | |||||