| Forum Home | ||||
| Press F1 | ||||
| Thread ID: 74802 | 2006-12-05 21:48:00 | New HDD not working | trinsic (6945) | Press F1 |
| Post ID | Timestamp | Content | User | ||
| 504487 | 2006-12-07 17:34:00 | The jumper pin is about 3mm thick incased in that little area it is next to impossible to get out. I done it once to reseat it but took a while to do it. Then use a needle to put under the little lip of the jumper and slide it up, simple | The_End_Of_Reality (334) | ||
| 504488 | 2006-12-07 21:30:00 | Nah it is. Its impossible to get if off as well :) It's just a jumper and very simple to change. As I said the symptoms you have are the same as I had when the drive wasn't set at 1.5. Are you sure it is set at 1.5. Change the jumper to other position and see if that helps. It will not break anything by trying this. Otherwise I don't know. |
berryb (99) | ||
| 1 2 | |||||