| Forum Home | ||||
| Press F1 | ||||
| Thread ID: 79340 | 2007-05-16 21:50:00 | Problem w/ boot and/or POST | chipmat31 (12273) | Press F1 |
| Post ID | Timestamp | Content | User | ||
| 550428 | 2007-05-16 21:50:00 | My heatsink/processor fan crapped out & I replaced it. Now when I boot, the PC goes through the POST & then stops at a screen that shows the BIOS type system configurations CPU ID/ucode ID : 0FC03A Base Memory : 640K CPU Clock : 2000 MHz Extended Memory : 1046528K L1 Cache : 128K L2 Cache : 512K Diskette Drive A: Diskette Drive B: Primary Master Disk : LBA, ATA any ideas??? |
chipmat31 (12273) | ||
| 550429 | 2007-05-16 22:04:00 | Not without any specs and as much info as you can give us | The_End_Of_Reality (334) | ||
| 550430 | 2007-05-18 09:46:00 | Did you remove the heat sink as well or just the fan? | johnd (85) | ||
| 550431 | 2007-05-18 21:21:00 | Did you remove the heat sink as well or just the fan? Yeah, removed the heatsink too. The mobo is a Chaintech VNF3-250, socket 754, Athlon 64 proc Possible damage to proc? thanks, Chip |
chipmat31 (12273) | ||
| 550432 | 2007-05-19 08:26:00 | You should reinstall using heat conducting compound to ensure good contact and no over-heating. | johnd (85) | ||
| 550433 | 2007-05-21 16:31:00 | You should reinstall using heat conducting compound to ensure good contact and no over-heating. Yeah I did that prior to posting on the site. I just ordered a new mobo/cpu. Thanks for the help... |
chipmat31 (12273) | ||
| 1 | |||||