| Forum Home | ||||
| Press F1 | ||||
| Thread ID: 88193 | 2008-03-18 11:21:00 | Mobo power plugs | bluezone (12434) | Press F1 |
| Post ID | Timestamp | Content | User | ||
| 650564 | 2008-03-30 21:02:00 | This (home.swipnet.se) The 30pin 0.5mm pitch FPC connector. (or something like it). And the 20cm (around 8") 30wire flexible flat cable. Near the bottom of this site, might be what youre after |
Speedy Gonzales (78) | ||
| 650565 | 2008-03-30 23:59:00 | MMMMMMM that looks interesting. | bluezone (12434) | ||
| 650566 | 2008-03-31 10:01:00 | Hi everyone got email from Shuttle people and email was: Regarding your concern about SB81P issue, please check the attached file. 14&16 pin are HD LED 17&19 pin are PW LED RST_SW(12) and PW_SW(15), you can connect with any other normal ground wire The file is: i206.photobucket.com |
bluezone (12434) | ||
| 650567 | 2008-03-31 10:14:00 | So the case you have now has it got wires/led/s a button/s, on the front of it?? If it has just connect them to those connectors you listed |
Speedy Gonzales (78) | ||
| 650568 | 2008-03-31 10:20:00 | nop the case i have has nothing its a old heavy SCSI 7 cd drive tower. going to have to install buttons and leds. Looking at getting this for the buttons. Metal Momentary SPST www.jaycar.co.nz For the leds i dont no yet. |
bluezone (12434) | ||
| 650569 | 2008-03-31 10:23:00 | Where are you near the city / Mt Eden somewhere? | Speedy Gonzales (78) | ||
| 650570 | 2008-03-31 10:29:00 | Rangoria 20mins from CHCH. This is the case. i206.photobucket.com |
bluezone (12434) | ||
| 650571 | 2008-04-04 10:30:00 | I suspect from the nomenclature that it should be the following... 1 Mouse Clock 2 Mouse Clock common 3 Mouse Data 4 Mouse Data common 5 Keyboard Clock 6 Keyboard clock common 7 Keyboard Data 8 Keyboard Data common 9 Keyboard Power 10 Keyboard Ground 11 Keyboard Power 12 Reset Switch 13 FP ground (Common Ground) 14 Hard Drive LED 15 Power Switch 16 Hard Drive Power Up 17 G?? LED B 18 Vcc (+5Volts) 19 G?? LED A 20 - 40 Sound connections A guess at GLEDA and B would be the earth points for the LEDs and the second Keyboard power (11) would do for the power LED. A multimeter would be the best test once you could have the ability to start it up. i206.photobucket.com What earth would be good for the power and restart? would the 2 below work for the grounds fot the power and restart? 10 Keyboard Ground 13 FP ground (Common Ground) |
bluezone (12434) | ||
| 650572 | 2008-04-05 15:24:00 | PSU i need is a Shuttle PC55 450w. | bluezone (12434) | ||
| 650573 | 2008-04-05 15:42:00 | Given up trying to get a psu as nun in New Zealand getting one from overseas just cost soooooo much the rip offs. So going to just buy a good psu and mod it found this in the mobo manual. i206.photobucket.com This is what the Shuttle PC55 450w PSU looks like. i206.photobucket.com |
bluezone (12434) | ||
| 1 2 3 4 | |||||