| Forum Home | ||||
| Press F1 | ||||
| Thread ID: 88490 | 2008-03-29 07:05:00 | No video signal/ constant reboots after upgrade! | gkar (5215) | Press F1 |
| Post ID | Timestamp | Content | User | ||
| 653986 | 2008-03-30 06:14:00 | When u cleared the BIOS/CMOS did you remove a jumper? If you did, did you put it back on the right set of pins?[/ No jumper with this board, just a button. And when you took it out of the case, did u put the ATX 12v plug in, if it uses it? Yes, I did. Thanks for the tips. |
gkar (5215) | ||
| 653987 | 2008-03-30 07:15:00 | Try starting up in safe mode, then disabling your graphicscard and rebooting. If computer then starts up using on board graphics it points to the newly installed card or more likely the drivers. This happened to me recently and I don't know how often I had to restart to get everything to work again. |
Incognito (6628) | ||
| 653988 | 2008-03-30 07:21:00 | Try starting up in safe mode, then disabling your graphicscard and rebooting. If computer then starts up using on board graphics it points to the newly installed card or more likely the drivers. This happened to me recently and I don't know how often I had to restart to get everything to work again. I'm afraid that's a bit difficult as I've cleared CMOS & as it now boots into BIOS, to allow settings, & I've no video signal at all, I can't even get to use F8. |
gkar (5215) | ||
| 1 2 | |||||