Forum Home
Press F1
 
Thread ID: 143693 2017-03-19 13:06:00 Custom PC will not Power On helkresh (17534) Press F1
Post ID Timestamp Content User
1433021 2017-03-19 13:06:00 Hi all,

First time poster .

I went to turn on my custom PC the other day and found it would not power on . The fans would twitch, but it would not "crank" so to speak . I have reseated the RAM, as well as testing them individually in slot 1, the motherboard power indicator is lit up, the capacitors are good, and I have tested the voltage on my Power Supply .

This says to me that power is reaching the motherboard, it reads the signal from the power button(its attempt to power up evidenced by the fans), and I am pretty sure my ram is fine .

I am at a loss as to what is wrong here . Any suggestions?

Here are the specs:

Motherboard: MSI Z97- Gaming 7 LGA 1150 Intel Z97 HDMI Sata 6Gb/s USB 3 . 0 ATX Intel Motherboard
Graphics Card: MSI GeForce GTX 980 Gaming 4g
Processor: Inter Core i5-4690k Devil's Canyon Quad-Core 3 . 5GHz LGA 1150 88W Bx80646154690K Desktop Proceesor
Ram: G . SKILL Ripjaws X Series 16 GB (2x8) 240-pin DDR3 SDRAM DDR3 2133 (PC3 17000)
Power: Rosewill Hive Series 850W Modular Power Supply


Thanks in advance!
helkresh (17534)
1433022 2017-03-19 16:06:00 Swap the PSu first. That's the easiest test. pctek (84)
1433023 2017-03-19 19:55:00 Power: Rosewill Hive Series 850W Modular Power Supply

Thanks in advance!

Look at all the failures in the customers reviews ....
www.newegg.com

As above. Most likely faulty power supply .
You could try disconnecting everything except the motherboard & see if it powers on
1101 (13337)
1433024 2017-03-19 20:32:00 Wouldn't it be showing up as faulty on a volt tester though? I got a green signal when I checked it. Or am I misunderstand some aspect of power supplies which is very very likely. helkresh (17534)
1433025 2017-03-19 21:00:00 The fans would twitch, but it would not "crank" so to speak. Thats a sign of a power related problem, as others have advised.

Theres power there but not enough to fire up the Computer.

Its generally one of two things, either a faulty power Supply or Motherboard failure.

The other thing that can cause it, is if something is causing a short Circuit.
wainuitech (129)
1433026 2017-03-19 21:03:00 Can I definitively test these without a replacement? helkresh (17534)
1433027 2017-03-19 21:10:00 Wouldn't it be showing up as faulty on a volt tester though? I got a green signal when I checked it. Or am I misunderstand some aspect of power supplies which is very very likely.

what voltage rails is that thing actually testing. How accurate is it. At what level would it show the PSU as faulty ?
Have you checked voltages with a multimeter. Are the voltages different under load .
A cheap tester almost certainly wont show noise/spikes due to bad PSU's

the 1st step is allways to try another PSU. Thats the easiest test ever .
You need to do some part swapping to track down the cause.
easier to swap PSU than motherboard

I have seen faulty USB port causing similar faults, but thats not very common . Unplug front USB, check back USB port for damage.
unplug all on/reset/led/sata/audio etc cables , start via shorting the on pins on the m/b itself
1101 (13337)
1433028 2017-03-19 21:15:00 Faulty caps , faulty mb can give the exact same fault .
more likely to be PSU , but could be any of your parts

2 choices
send it out for repair, or start buying parts to swap out for testing.
1101 (13337)
1433029 2017-03-20 01:48:00 Well a couple things you can try without parts to swap but it does seriously limit your options.

1. A little risky so try at your own risk.
If you get a piece of wire and insert it into the power connector between the green wire (pin 16) and one of the black ones it will force the PSU on. If it's just an issue with it starting up occasionally that will make things happen.
I've only seen it actually work once though, on a faulty motherboard that wasn't sending the power on signal.

Also note if you are voltage testing without a load it doesn't really mean much, many faults are not obvious until you try to draw some current.

2. Disconnect absolutely everything not required to start up. All USB devices, all hard drives, optical drives, peripherals, everything but the keyboard mouse and screen. Then see if you can get into the BIOS screen. If that works start reconnecting things one by one and see what happens.
dugimodo (138)
1433030 2017-03-20 09:09:00 Did it turn on / post before?? Speedy Gonzales (78)
1