| Forum Home | ||||
| PC World Chat | ||||
| Thread ID: 77827 | 2007-03-24 02:27:00 | Cordless drill. | Cicero (40) | PC World Chat |
| Post ID | Timestamp | Content | User | ||
| 535404 | 2007-03-24 07:54:00 | Oh Darn! I have an evening job :( If you don't want either of these transformers, they can go back under the hot water cylinder and languish again, otherwise, PM me and I can send you the one that you choose. |
R2x1 (4628) | ||
| 535405 | 2007-03-24 08:19:00 | www.1website.co.nz Here |
pctek (84) | ||
| 535406 | 2007-03-24 08:30:00 | www.1website.co.nz Here Thanks for that PC,I note they only ship to USA. |
Cicero (40) | ||
| 535407 | 2007-03-24 11:39:00 | Cost? What is so special about a drill from the US? The charger will be 110v, so you would need an auto transformer, or one of those small switched mode voltage converters. Edit: I bought a $9 one from Supercheap auto :) it has a real chuck, ie. a chuck with a key. It has done a lot of work and is going fine. SuperCrap. Drill didn't last a month and the nut driver didn't last one job. Battery charge was hopeless. Total waste of money. Since bought an 18volt Hitachi for about $360 and it has been a far better investment |
mikebartnz (21) | ||
| 535408 | 2007-03-24 21:02:00 | Thanks for that PC,I note they only ship to USA. Does it need to be that exact model? www.rs-components.co.nz www.powertools.net.nz |
pctek (84) | ||
| 535409 | 2007-03-24 21:25:00 | Does it need to be that exact model? www.rs-components.co.nz www.powertools.net.nz Thanks again PC. You will note the IMPACT driver,which I am after,is $722. This not a cordless drill,but a cordless impact driver. If one was to use a drill with the amount of tarque generated by one of these,it would break your wrist. They are slow to take off here,but are being used by tek screw users etc. |
Cicero (40) | ||
| 535410 | 2007-03-24 21:48:00 | Funny that, Our main use of cordless drills is to remove Tek screws, and the average screw will quite happily burn out the average drill within seconds. | Metla (12) | ||
| 535411 | 2007-03-24 22:25:00 | Funny that, Our main use of cordless drills is to remove Tek screws, and the average screw will quite happily burn out the average drill within seconds. The impact driver I have at the moment,has 135nm of torque,that enrgy is not felt on wrist. Ask any pro tek screw user. |
Cicero (40) | ||
| 535412 | 2007-03-25 05:54:00 | My mistake, We dont use cordless drills for Tek screws, we have a bunch or reguler ones we run off a large generator. No idea why I was thinking cordless. | Metla (12) | ||
| 535413 | 2007-03-25 06:06:00 | My mistake, We don't use cordless drills for Tek screws, we have a bunch or regular ones we run off a large generator. No idea why I was thinking cordless. Bound to become confused after running a smacking campaign.:rolleyes: |
Cicero (40) | ||
| 1 2 3 | |||||