| Forum Home | ||||
| Press F1 | ||||
| Thread ID: 97432 | 2009-02-15 08:46:00 | Antec Nine Hundred - GFX card support bracket | sinclair27 (14502) | Press F1 |
| Post ID | Timestamp | Content | User | ||
| 748239 | 2009-02-15 08:46:00 | I have an Antec Nine Hundred case, ASUS P5Q Pro motherboard and an ASUS ATI 4850 graphics card. Included with the case accessories is a full length PCI-E graphics card 'support bracket' which supports the weight of the video card. At first I couldn't fit the support bracket onto the card so just didn't bother with it. Now a few weeks later, I have noticed the card is sagging! So I have attempted to put the support bracket on again with no success. I was hoping someone else has a similar setup to me and could guide me through installing this support bracket (or simply tell me it is not possible and not to waste my time). Thanks! |
sinclair27 (14502) | ||
| 748240 | 2009-02-15 08:48:00 | The instuctions manual didn't supply sufficient installation instructions...sadly | sinclair27 (14502) | ||
| 748241 | 2009-02-15 09:08:00 | Antec Nine Hundred has a VGA support bracket? I don't think so. I think you're mistaking it for the optional 12cm fan bracket. | qazwsxokmijn (102) | ||
| 748242 | 2009-02-15 09:11:00 | The videocard may have come with a bracket (this one did for small cases) Dont see why you need it, the card should have one already. All you have to do is secure it / screw it in |
Speedy Gonzales (78) | ||
| 1 | |||||