Forum Home
Press F1
 
Thread ID: 143982 2017-05-29 21:27:00 Motherboard Issue? bk T (215) Press F1
Post ID Timestamp Content User
1435889 2017-05-29 21:27:00 Turned ON my PC this morning and my Asus Z97-A greeted me with this:

"Please enter SETUP to recover BIOS SETTING
Press F1 to Run SETUP"

I pressed F1, enter BIOS setup, DID nothing, exit and saved settings, it boots normally.

This is the second time it greeted me with the same error. The first time was about 2 weeks ago.

Motherboard about to go? Battery? It keeps the time, though.
bk T (215)
1435890 2017-05-29 22:37:00 You could replace the CMOS battery, they are cheap and it's not difficult, and see if that resolves the issue. KarameaDave (15222)
1435891 2017-05-30 00:37:00 Some hardware changes can trigger that as well, but normally only RAM or CPU.
Try the battery as KarameaDave suggested.
dugimodo (138)
1435892 2017-05-30 01:05:00 OK. Will replace the battery and see how it goes. bk T (215)
1435893 2017-05-30 02:05:00 Do you leave the computer on? Only time that has happened to me is following a power cut while the PC was still on. Pressed F1 and away we went. Bryan (147)
1435894 2017-05-30 02:11:00 Battery replaced, but something's not quite right:

Entered BIOS and noticed that the date and time have changed (expected, as battery removed and replaced), tried to change the date but couldn't do so in 'Advance Mode'; it's greyed. Changed back to Ezy Mode and it allows me to reset the date and time.

I have the latest BIOS version, i.e. 2801 . Does it matter whether it's 64 bit or 32 bit? I installed the x64 bit.
bk T (215)
1435895 2017-05-30 03:44:00 Battery replaced, but something's not quite right:

Entered BIOS and noticed that the date and time have changed (expected, as battery removed and replaced), tried to change the date but couldn't do so in 'Advance Mode'; it's greyed. Changed back to Ezy Mode and it allows me to reset the date and time.

I have the latest BIOS version, i.e. 2801 . Does it matter whether it's 64 bit or 32 bit? I installed the x64 bit.

So what is not right?
You changed date and time, maybe they are only accessible in ezy mode.
Did you try clicking on the greyed out date and time and adjust it then?

32 or 64 should do the same job.
KarameaDave (15222)
1