| Forum Home | ||||
| Press F1 | ||||
| Thread ID: 102101 | 2009-08-07 02:56:00 | OpenVPN & VLANs - server config problem | Erayd (23) | Press F1 |
| Post ID | Timestamp | Content | User | ||
| 798965 | 2009-08-07 02:56:00 | Hi Guys, I'm trying to set up OpenVPN to do the following: Tunneling is done at layer 2 (tap) There are several client groups, none of whom I can trust The groups don't trust each other either Each client group needs to be segregated on the server, in a way that I can trunk Each client connecting to the server is assigned to a group based on their authentication information There can only be one server instance My current idea for achieving this is to put each client group into a separate vlan, but the problem is that one server instance == one tap interface, i.e. all client groups share the same tap interface, and therefore I can't find a way to separate them. I am more than happy to do some more scripting to achieve this if required, but at the moment I'm stumped as to what I should do. Any ideas? Thanks, Erayd |
Erayd (23) | ||
| 798966 | 2009-08-07 11:33:00 | This may do what you wont: www.tslab.ssvl.kth.se Not based on OpenVPN, but could be an alternative. |
ughnz (8297) | ||
| 798967 | 2009-08-08 00:07:00 | Sorry - thanks for the suggestion, but that completely misses the point of what I'm trying to do. Note also that OpenVPN is basically a requirement - it would take a *very* compelling reason for me to ditch it and replace it with something else. |
Erayd (23) | ||
| 1 | |||||