| Forum Home | ||||
| Press F1 | ||||
| Thread ID: 111935 | 2010-08-17 08:40:00 | How can I reduce my fan speed? | 8ftmetalhaed (14526) | Press F1 |
| Post ID | Timestamp | Content | User | ||
| 1128763 | 2010-08-18 14:17:00 | I think you basically would connect the positive wire from one fan, connect it to the negative wire on the other, then use a plug for the remaining two wires and plug it in, but dont take my word for it, You are right |
Roger Hunt (13648) | ||
| 1128764 | 2010-08-18 14:35:00 | Running win 7 pro x64, just ran it as an admin and had to change all my pwm's or whatever to being software controlled for the front fan to be controllable. I'll muck with it when I get a minute and see if I can get my top exhaust or the rear green one slowing down any. Might be a job for tomorrow arvo. Thanks for all the help so far. But for now I'm off to bed. |
8ftmetalhaed (14526) | ||
| 1128765 | 2010-08-20 06:02:00 | To get the 5 volt rail.. There are spare wires available from the power supply, eg floppy disk power connector. Red is plus 5 volts. Black is negative. Your fan black and red wires correspond, forget the about the third wire sensor connection. You asked for this information earlier in the postings. Does nobody else know this? |
PENTIUM (426) | ||
| 1 2 3 4 | |||||