| Forum Home | ||||
| PC World Chat | ||||
| Thread ID: 114634 | 2010-12-11 06:03:00 | Dremel? or equivalent | The Error Guy (14052) | PC World Chat |
| Post ID | Timestamp | Content | User | ||
| 1160657 | 2010-12-14 19:41:00 | Just a quick Q, if I was to cut out a design like this (4.bp.blogspot.com) (which is not the design but its the general idea) what sort of cutting bit or tool would you recommend? | The Error Guy (14052) | ||
| 1160658 | 2010-12-14 20:03:00 | I presume that the design is about the same size as onscreen. I have been involved in design and manufacture for a while. If you want to cut it out of 7mm plastic it will be very difficult to do by hand/with a dremel. It will look nasty. When I have had designs like yours to cut out I have always used laser cutting. There a quite a few places that do this. If the design is large - ie bigger than A4 I would have the facilities to cut it out for you. I have a CNC router. Message me Thanks |
superoman (6703) | ||
| 1160659 | 2010-12-14 21:38:00 | Final design will be around 12x14 (approx) cm. | The Error Guy (14052) | ||
| 1 2 3 4 | |||||