Forum Home
Press F1
Thread ID: 2306	1999-08-15 02:05:00	'my screen goes blank'	Guest (0)	Press F1

Post ID	Timestamp	Content	User
2692	1999-08-15 02:05:00	Hi there I can't see my screen. (It is working have hooked it up to my lap top to send this.) I was adjusting the 'screen area' in settings in display properties in control panel. When I pressed apply the screen flashed and disappeared only to not so far appear again. Now when I boot up the screen goes through the boot up shows windows 98 briefly flashes a bit and then disappears. I can get into set up but that is all. So how to I change the settings for the screen (that it obviously can't cope with)to back to how they were without being able to see anything ? regards Ken Maclaren	Guest (0)
2693	2001-05-07 14:04:00	Start in safe mode (this will load the default windows video drivers)and reset the screen size from there. It might also pay to reduce you refresh rate to around 60hz. You could also try changing your video adaptor to the standard VGA driver (right click on desktop, select: properties, settings advanced, adaptor, change, next, display a list of all drivers..., show all hardware, standard display types). After rebooting, reinstall the correct drivers.	Guest (0)
2694	2001-05-07 14:05:00	Start in safe mode (this will load the default windows video drivers)and reset the screen size from there. It might also pay to reduce you refresh rate to around 60hz. You could also try changing your video adaptor to the standard VGA driver (right click on desktop, select: properties, settings advanced, adaptor, change, next, display a list of all drivers..., show all hardware, standard display types). After rebooting, reinstall the correct drivers.	Guest (0)
1