| Forum Home | ||||
| Press F1 | ||||
| Thread ID: 123869 | 2012-03-21 19:48:00 | Turbocad will not start | Thomas01 (317) | Press F1 |
| Post ID | Timestamp | Content | User | ||
| 1266253 | 2012-03-21 19:48:00 | Years ago I bought Turbocad. Darn difficult program but once you get the hang of it isn't bad. But recently I bought a new computer (HP), and decided I wanted to use TurboCad again. I used the installation disk and it went in fine. It worked but did point out I only had so many days left to register. Any attempt to register was met with a response that the site could not be found. Eventually there were no days left and the thing will no longer start. I have contacted Turbocad with a request for help but judging by previous experience in that direction I will not even get a response. Needless to say so far I have been ignored. Turbocad wasn't cheap - and I paid good money for it. Any help to get the thing working would be appreciated. Tom |
Thomas01 (317) | ||
| 1266254 | 2012-03-22 07:38:00 | You could have a look here (www.freecad.com) to see if you can find a free replacement. Quite a while ago I tried QCAD but it would have changed too much for me to say what it is like. | mikebartnz (21) | ||
| 1266255 | 2012-03-22 08:11:00 | You may find because its quite an old product the activation pages/links have been changed over the years. On their support near the bottom it states "Please note that support for discontinued or older versions of current products is limited to the information provided on our website." Just something else to try Have a read of this (st.imsisupport.com) try the first option where it says ---please submit a ticket to -- -- you may have already been down this path ?? |
wainuitech (129) | ||
| 1 | |||||