Forum Home
Press F1
Thread ID: 5682	2000-09-09 04:40:00	Installing Second Drive	Guest (0)	Press F1

Post ID	Timestamp	Content	User
6266	2000-09-09 04:40:00	I have just installed another hard drive into my Pentium 133. Its a 7.5Gb drive, I installed it as a master on the second IDE controller, the other device on that controller is my CD-ROM which I set as the slave. I used IDE HDD Auto Detection to detect the drive without any problems. I checked the CMOS setup and both disks are shown, both also show on boot up. When I went into FDISK to partition and format the disk but I get an error message reading 'Can't access drive 2'. I don't have a drive letter for the new drive because it can't be accessed. Can anybody help? (My original disk 1.5Gb is still the primary boot dosk)	Guest (0)
1