Forum Home
Press F1
 
Thread ID: 19899 2002-05-25 07:19:00 FDC failure Guest (0) Press F1
Post ID Timestamp Content User
50681 2002-05-25 07:19:00 Any advice on this failure would be very much appreciated.
In the middle of a defrag,everything froze,no KB or mouse action,no ctr-alt-del.After a shutdown by doing a reset,it takes ages to try to boot with the following messages.
KeyB detected
Mouse detected
Fixed disk
Cd rom
3 beeps then FDC Failure
Press F1 to continue
After pressing F1, the setup screen appears at page 1 but with no KB or mouse to control anything it is not much use.
Thanks for any info.
Guest (0)
50682 2002-05-25 11:22:00 3 beeps is usually the memory has packed a sad - try with known good memory.

FDC failure - either the floppy drive has died, the cable is loose, or the I/O card/circuitry has died or all three.
Check the floppy cable is seated, or try a known good floppy cable, or a replacement floppy drive or a replace I/O card.
Guest (0)
50683 2002-05-25 20:53:00 Hi,
Thanks for the info.
Regards,
D
Guest (0)
1