| Forum Home | ||||
| Press F1 | ||||
| Thread ID: 129332 | 2013-02-18 22:56:00 | K8 NPT?? | NZHawk (4093) | Press F1 |
| Post ID | Timestamp | Content | User | ||
| 1328768 | 2013-02-19 00:41:00 | I have no idea what you do I dont have the mobo or the manual. It should save settings in the BIOS like any other system | Speedy Gonzales (78) | ||
| 1328769 | 2013-02-19 00:44:00 | Cool, I'll try to find a manual | NZHawk (4093) | ||
| 1328770 | 2013-02-19 01:11:00 | This is what the Gigabyte website describes as the problem - It means that data of the memory registry of K8 processor has been updated to DMI when the system is turned on. Those data are aimed to be written back to processor when PC wakes up from sleep mode of S3(STR). |
NZHawk (4093) | ||
| 1328771 | 2013-02-19 01:21:00 | There's a lot of different places where people have seen the same thing. If you do a search in Google. | Speedy Gonzales (78) | ||
| 1328772 | 2013-02-19 01:24:00 | Ok BIOS updated but still cycles through boot it says Verifying DMI Pool Data - then goes to the start up option page .. Safe Mode... but neither normal nor safe mode work any further suggestions |
NZHawk (4093) | ||
| 1328773 | 2013-02-19 01:44:00 | Try booting from a Linux CD, see if it loads OK. If it doesn't disconnect the HDD, and try again - see if it will run off the CD. Process of elimination to find out whats causing it. |
wainuitech (129) | ||
| 1328774 | 2013-02-19 01:46:00 | ok | NZHawk (4093) | ||
| 1328775 | 2013-02-19 02:29:00 | took a while but booted successfully to Linux CD | NZHawk (4093) | ||
| 1328776 | 2013-02-19 02:38:00 | With or without the HDD attached ? If it was attached, will Linux read the drives contents ? If it was attached, try unplugging it and try again, does it load Linux any faster ? Just trying to phantom out if its the HDD /Connection giving problems. |
wainuitech (129) | ||
| 1328777 | 2013-02-19 02:40:00 | with | NZHawk (4093) | ||
| 1 2 3 | |||||