Forum Home
Press F1
 
Thread ID: 36618 2003-08-14 11:53:00 CPU at 60 degrees heni72847 (1166) Press F1
Post ID Timestamp Content User
167798 2003-08-14 11:53:00 is it normal for a AMD 2000+ 17GHz to reach 60 degrees
normally it's 50-54
heni72847 (1166)
167799 2003-08-14 11:58:00 I seem to recall something about AMD processors overheating a fair bit, so it could be normal for an AMD CPU.

However, I'd still say that even 50 degrees celcius is quite high, and 60 verging on unacceptable.
agent (30)
167800 2003-08-14 12:10:00 I have a 950 Duron that hums along at 60C+ but my xp 1800 rarely gets over 50C its 35 at the mo. Check out AMD's site for running temperatures. AFAIK, get worried if its getting around 75 hit the off button if its 80. The overclockers should be able to tell you more.

Cheers Murray P
Murray P (44)
167801 2003-08-14 12:12:00 BTW, what are you doing/running when it hits that temp?

Cheers Murray P
Murray P (44)
167802 2003-08-15 05:18:00 can't really remember...
just ms word, IE and something els

nothing that needs heaps of cpu like encoding video or anything...
heni72847 (1166)
167803 2003-08-15 05:32:00 What core is that Athlon? The 2000+ was released in both Palimino and Throughbred. The original Palimino was very hot especially the 2000+ & 2100+ as these were the last two Athlons released with the Palimino core. The throughbred was a far better core, Intel fans often claim their CPU's run cooler but the lower speed Throughbreds were very cool and often get a bad rap because of their predessors(Thunderbird + Palimino).

Those temps are too hot for either of these two cores, but if it is a Palimino then dont expect it to drop by much. A Throughbred should be running alot cooler than that. Personally i would call a Throughbred thats running over 40 degress not under load too hot. What sort of cooling do you have on that CPU? Did u install it yourself? Did you apply thermal paste? Did you buy that CPU new? Retail or OEM?

The best way to lower those temps is to take off the HSF, grab some decent thermal paste(such as Artic Silver) and remount the processor. It may turn out that your HSF isnt up to the task of cooling that CPU( E.g you upgraded and are using the HSF off an older system).

Dont worry its not goin to blow up but it will pay to keep an eye on temps till you fix the problem. Athlons dont tend to blow up untill about 85-90 degrees c. I once had my ole trusty Duron up at 80 degrees and it survived.
Pete O'Neil (250)
167804 2003-08-15 08:17:00 from recall 110 degrees is meltdown for an athlon so 60 degrees is nothing to worry about, I would argue that it is probably running hotter than a normal set up, but who cares, its no where near a danger zone roofus (483)
167805 2003-08-15 09:30:00 Yes, it wont blow up at 60 degC, but that is too hot. Remember we are in winter, what about when the ambient temperature is another 10C or so higher?

Even allowing for measurement uncertainty, the aim should be to get the cpu temp. down to about the 50C mark. My 1.33Ghz Athlon is currently said to be 40/41C, with system temperature reported as 25C.
Terry Porritt (14)
167806 2003-08-16 02:50:00 > from recall 110 degrees is meltdown for an athlon so
> 60 degrees is nothing to worry about, I would argue
> that it is probably running hotter than a normal set
> up, but who cares, its no where near a danger zone

Well I have a new Gainward Nivida FX5900Ultra video card and the warning is set at 104 degrees to slow it down which means it will go above this temp.

It humms along at about 50 to 60 degrees
Big John (551)
167807 2003-08-16 02:55:00 My Athlon was reading a temp or 63 Degrees but after a Bios update it came up as 36 degrees, turns out there was a problem with the Bios temperature polling which was fixed with the bios update, maybe yours is the same. I believe it affected several motherboard using the award bios Odin (227)
1 2