| Forum Home | ||||
| Press F1 | ||||
| Thread ID: 38611 | 2003-10-12 20:20:00 | New Motherboard | pmutton (4092) | Press F1 |
| Post ID | Timestamp | Content | User | ||
| 182695 | 2003-10-12 20:20:00 | I Have installed a new Motherboard, processor and DDR ram but where I turn on the power the CVP fan starts but the POST does not run. Also no video out to the monitor. The board is a PC DDR 266 with a AMD duron 1.2 Any ideas? I have tried a different power supply but still no joy |
pmutton (4092) | ||
| 182696 | 2003-10-12 20:22:00 | I have a similar problem suspect its a ddr ram speed incompatibilty | kiwibeat (304) | ||
| 182697 | 2003-10-12 20:29:00 | check video card is setted correctluy and ram is seated ok. small thing that trips a few people is some mobo's require you to hit the reset switch before they will run. |
tweak'e (174) | ||
| 182698 | 2003-10-12 20:36:00 | OK, Video is onboard and have tried a PCI video card, still no good Have tried the reset button as well |
pmutton (4092) | ||
| 182699 | 2003-10-12 20:40:00 | Check the FSB jumper on the mobo. Needs to be set to 100MHz for a Duron CPU. Most likely this is set to 133MHZ. I have been caught out with this a few times :) |
CYaBro (73) | ||
| 182700 | 2003-10-12 23:40:00 | No, the board is set to 100Mhz. Good try though. |
pmutton (4092) | ||
| 1 | |||||