Forum Home
Press F1
 
Thread ID: 44484 2004-04-20 11:25:00 Help with bios update wotz (335) Press F1
Post ID Timestamp Content User
230784 2004-04-21 12:55:00 Thanks for all the replies so far.
Pheonix, when tried to boot from the altered boot disk I got an error "Dynamic Disk Overlay has failed to load" or something along those lines.
wotz (335)
230785 2004-04-22 06:15:00 There is even yet another way of doing what you want wotz, and that is to get a PCI IDE controller card, probably an ATA100. It has its own bios on the card, and being newer will recognise bigger drives. It just takes a tad longer to boot as there are now two bios procedures to go through.

The big advantage is that it gives you a lot more IDE connectors so you can have a multiplicity of hard drives or CDROM/DVD etc.
Terry Porritt (14)
230786 2004-04-22 08:28:00 Was starting to get brave about a flash, but saw this on the Jetway website (www.jetway.com.tw)


I don't see either Winbond or SST. 1998 does show. Does this mean I can can only update the BIOS, not save it, or can I not use the Award utility?
wotz (335)
230787 2004-04-22 10:21:00 I cant understand their Japlish or Chinalish either :)
I suppose it makes sense to those who wrote it.
It's not very good for an important operation like bios flashing.

I wouldnt do anything unless you are absolutely sure you have the correct bios .bin flash file for your motherboard.

If you pause the boot screen with the pause button when the bios information appears at the bottom of your screen, (they tell you to wirte down the info on the thrid line :) ) you can get the details of your current bios.
The manufacturers site may well have an archived list of the bios updates that have been available hopefully you will see yours and also any udates subsequent to your existing one.
Terry Porritt (14)
230788 2004-04-22 11:57:00 I searched around a few sites and got some more info. Poked the disk in, crossed my fingers and held my breath. I came out the other side a bit blue but with an updated BIOS and a HD being reported the correct size.

Thanks for the help.
wotz (335)
230789 2004-04-23 02:16:00 Well done. You had everything right. Next time wont be so nerve-wracking :)
Cheers
Terry Porritt (14)
1 2