| Forum Home | ||||
| Press F1 | ||||
| Thread ID: 58821 | 2005-06-13 06:29:00 | Interesting Mobo | Xika (8344) | Press F1 |
| Post ID | Timestamp | Content | User | ||
| 363487 | 2005-06-13 06:29:00 | I have a Full Yes Industrial 82430VX. After searching for a manual of this Mobo, which I nor the Web has, i had to settle for a page (www.elhvb.com) which explained the boards jumper settings. The Processor the board has on it now is a Pentium 133, but alongside the Socket 7 socket is a Slot 1 slot. The page on jumpers does nothing to explain any jumper settings for Slot 1. Would this Mobo be able to handle all Slot 1 speeds? | Xika (8344) | ||
| 363488 | 2005-06-13 06:42:00 | I'd say it applies regardless. Are you really sure you want to bother though? Getting on a bit... | pctek (84) | ||
| 363489 | 2005-06-13 06:52:00 | Yeah, I'm trying to use it for Half-life 1 lans, it already plays, at 10fps, in a window sized 400x300 in 640x480 resolution. A little performance boost can't hurt. The CPUs already overclocked to 180Mhz, 3x60Mhz, and it has 48megs of ram. Or should I just consider a cheap P166 MMX off trademe? btw Slot 1 CPUs aren't too expensive on trademe. |
Xika (8344) | ||
| 363490 | 2005-06-13 07:00:00 | Might I mention that the RAM can go up to 128MB but over 64MB, as i've read about Intel's 82430VX chipset, it slows down for a reason I can't remember. The mobo has 4 72pin SIMM slots and an SDRAM slot (I think) |
Xika (8344) | ||
| 1 | |||||